关于意普

1.Cover the safety light screen with your hand, and observe whether the light switch is normal.

2.The position of the photoelectric protection device of the punching machine shall not be changed at will during use.

3.In the protection zone, with the hand to block the light curtain, the machine should be able to stop working immediately, reaction time < 15ms.

4.When the slider is at the bottom dead point (180 degrees), the light curtain is blocked, and the machine tool slider should be able to return.

5.For presses that can only achieve top dead center protection, when the slider stops on the top dead center, the slider blocks the light curtain, and the next operation cannot be started

6.After the mold is replaced, the safety distance and location of the protective device must be adjusted by the special management personnel.

7.When disassembling the grating and the transmission line, the power should be turned off first, and it must be operated by professionals to avoid the occurrence of dangers.

8.Check that the transmitter and receiver of the safety grating are correctly assembled with their respective cables, and that the terminals of the cables are correctly connected to the power supply and controller.